We're so excited to share that we've turned our work on the enclosure into a story as we promised!
If this is your first time hearing about the project, we'd love for you to head over to our documentation area and check out our journeys!
Enjoy the awesome shots - get Infected!
We've got some great news to share!
We've been hard at work on our CI system and components to get more out of it.
We've made some major improvements to our infrastructure and moved our blog into its own ecosystem.
And we're not stopping there!
We're going to focus on documenting more to make your experience even better.
Stay tuned for more updates!
The just finished slot cover is the last part of the outer shell in its minimal setup. In my opinion, it would be possible without the printing of the brim.
Once again, it fits.
That is really, really impressive.
And now enjoy our sexy final shot.
Put the lid on! It just fits. Simply brilliant.
The takeaways:
The rounded edges need tweaking.
The supports (grid, snug, organic) were all difficult to remove. It has to work without them.
Printing on the textured sheet shows a more consistent look.
There are a lot of ideas that will go into the next iteration.
All in all, absolutely gorgeous.
Finally, after 7 hours of 3D printing, we finished the second half of the butt, the main shell. The parts fit together pretty well, but need some fine tuning to just snap into place.
Really amazing!
Stunningly beautiful! After 7 hours of 3D printing, we are proud to show you the half of the butt.
Well done!
Hooray! We have started to print the components of the micronom enclosure. Here you can see the top microphone cover with its controls.
